PRESIDENT RANDY II FCC Manuel Du Propriétaire page 21

3.
Press the s or t key (3) to select the
4. Short press the MENU key (7) to validate the menu.
5.
Press the s or t key (3) to alternate between ON and OF
6. Short press the MENU key (7) to validate.
On memorize the current channel into the SCAN SKIP memory.
When a channel is stored in the memory,
display next to the channel number.
OF erase the current channel from the SCAN SKIP memory,
disappears from the display. See the § SKIP page 12.
10) CODE SET
For simplicity, in this manual we will speak of CODE to indicate
both a CTCSS tone and a DCS code, of GENRE to indicate the
kind of code (CTCSS, DCS or OFF = no code). TYPE indicates
whether this is a TX transmission or an RX reception and MODE
specifies the operating mode, Identical I d or different DF. See
§ CTCSS/DCS page 23.
This menu allows you to configure the operating mode of the
CTCSS/DCS function and to store the CTCSS/DCS codes.
2 operating modes:
- I d means that the code used will be identical for transmission
(TX) and for reception (RX).
DF means that the user can use one code (or OFF = no code) for
-
transmission (TX) and another (or OFF = no code) for reception
(RX).
Press the s or t key (3) to select the channel to be set.
Long press MENU key (7) to enter the MENU.
OPERATING MODE
1.
Press the s or t key (3) to select the
2. Briefly press the MENU key (7) to confirm. The operating mode
flashes (I d or DF).
3. Press the s or t key (3) to select the desired operating mode.
STORING A CTCSS/DCS CODE
Depending on the operating mode used, the procedure differs:
Identical mode I d
4. A short press on the MENU key (7) makes the genre blink ("CTCSS",
"DCS" or "OFF" no genre).
5. Press the s or t key (3) to select the genre or...
21
menu.
appears in the
is displayed.
menu.