Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.
Connect the AC power supply (C7) to the home charger (C8).
3.
Plug the AC power supply (C7) into a 110/220 V socket.
2) USING THE CAR ADAPTER
1.
Clip the home charger (C8) to the bottom of the unit in any sense.
2.
Plug the car adapter (C10) to the Home charger (C8).
3.
Plug the cigar lighter plug of the car adapter (C10) into your
vehicle (12 V only).
-
The charge begins.
mode and
-
disappears when the unit is fully charged.
3) CHANGING THE BATTERY PACK
The battery pack is pre-installed in the unit. If you need to replace
the battery pack :
1.
Unscrew the battery pack door (E). If necessary, remove the belt
clip (C5) or the microphone support (C4) to reach the screw.
2.
Disconnect and remove the old battery pack.
3.
Connect the new battery pack.
4.
Screw then the battery pack door (E).
Note: The battery pack is provided uncharged, so you must
charge the battery pack before using it with the transceiver.
4) LOW BATTERY FEATURES
When the battery is uncharged the RX/TX LED (16) blinks yellow.
A continuous beep sounds in TX mode.
H) TECHNICAL CHARACTERISTICS
1)
GENERAL
- Channels
- Modulation modes
- Frequency ranges
- Weather channels
- Antenna impedance
- Power supply
- Dimensions
- Weight without antenna
appears on the display to indicate charging
indicates the charging level.
: 40
: AM/FM
: from 26.965 MHz to 27.405 MHz
: 162,400 MHz to 162,550 MHz
: 50 ohms
: 13.8 V (Mobile configuration)
inches : 5.98 (H) x 2.62 (W) x 1.46 (D)
mm : 152 (H) x 66.5 (W) x 37 (D)
: 0.67 lb with battery pack
24
blinks on the display.
7.4 V (Handheld configuration)
305 g with battery pack,
Publicité
Table des Matières
