Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.
Press the MENU key (7) to confirm the genre. The code value
flashes (unless OFF selected).
7.
Press the s or t key (3) to select the code (from 01 to 38 for
CTCSS and 001 to 104 for DCS).
Different Mode DF
4.
A short press on the MENU key (7) makes the type RX blink.
5.
Press the s or t key (3) to select the RX or TX type.
6.
A short press on the MENU key (7) validates the choice of type.
The genre value flashes ("CTCSS", "DCS" or "OFF" no code).
7.
Press the s or t key (3) to select the genre or...
8.
Press the MENU key (7) to confirm the genre. The code value
flashes (unless OFF has been selected).
9.
Press the s or t key (3) to select the code (01 to 38 for CTCSS,
001 to 104 for DCS).
10. Press the MENU key (7) to confirm the selected code. Repeat
from point 4 for set the second type.
11. If you don't need to set the second type, long press the MENU
key (7) to validate and exit the MENU.
12. If no key is pressed, the device exits the MENU after 10 seconds
without saving the changes.
The default mode is I d (Identical). The default genre is OFF.
11) RESET
This function allows to erase the SCAN SKIP memory or restore
factory parameters.
1.
Long press the MENU key (7) to enter the MENU.
the display.
2.
Press the s or t key (3) to select the
3.
Short press the MENU key (7) to validate the menu.
4.
Press the s or t key (3) to select
5.
Short press the MENU key (7) to validate the reset.
erase all the channels stored on the SCAN SKIP memory.
They are now enabled to be scanned (see the § SKIP page 12).
restore all the factory parameters.
F) FUNCTION WITH PTT SWITCH
1) NOISE GATE
Press and hold the PTT switch (14).
-
(PTT + VOX)
22
appears on
menu.
or
Publicité
Table des Matières
