Eco Mode - PRESIDENT RANDY II FCC Manuel Du Propriétaire

4.
Press the s or t key (3) to activate (On) or deactivate (OF) the
KEY BEEP function.
5. Press the MENU key (7). A short press to validate and stay in the
MENU or a long press to validate and exit the MENU.
6. If no key is pressed, the unit exits the MENU after 10 seconds
without saving the modifications.
Default value is On.

4) ECO MODE

This function allows to save your battery. The unit goes in standby
mode, LCD backlight off, RX in standby*, etc.
1. Long press the MENU key (7) to enter the MENU.
the display.
2.
Press the s or t key (3) to select the
3. Short press the MENU key (7) to validate. The current value blinks.
4. Press the s or t key (3) to deactivate (OF) the ECO MODE
function or select between the 3 levels 01 (Low), 02 (Middle)
and 03 (High).
5. Press the MENU key (7). A short press to validate and stay in the
MENU or a long press to validate and exit the MENU.
6. If no key is pressed, the unit exits the MENU after 10 seconds
without saving the modifications.
Default value is 02 (Middle).
*Level 01: 250 ms RX active / 250 ms RX inactive
*Level 02: 250 ms RX active / 500 ms RX inactive
*Level 03: 250 ms RX active / 1 s RX inactive
Note: If level 03 is selected, the transmitting power automatically
changes to L (low). The H (high) power remains available but will
be reset to L if the device is switched off and then on again.
See HI/LO TRANSMITTING POWER page 16.
5) TONE
This function allows to adjust the reception tone.
1. Long press the MENU key (7) to enter the MENU.
the display.
2.
Press the s or t key (3) to select the
3. Short press the MENU key (7) to validate. The current value blinks.
4.
Press the s or t key (3) to select between the 11 levels from -5
to 5.
5. Press the MENU key (7). A short press to validate and stay in the
MENU or a long press to validate and exit the MENU.
menu.
18
appears on
menu.
appears on