Function With Ptt Switch; Charging The Randy Iii - PRESIDENT Randy III Manuel D'utilisation

How to proceed:
- Switch off the transceiver
Turn on the power while pressing the F (7) key. The letter corre-
-
sponding to the configuration is blinking.
- In order to change the configuration, use the sor t key (3).
- When the configuration is selected, long press on the F (7) key.
The letter corresponding to the configuration is continuously
displayed. At this stage, confirm the selection by switching off
then switching on again the transceiver.
See tables on page 56 ~ 61.
G) FUNCTION WITH PTT SWITCH
1) NOISE GATE
Press and hold the PTT switch (14).
-
Short press the F key (7) to activate (On) or deactivate (OF) the
-
NOISE GATE. "
Noise Gate: Prevents amplification of background noise. This
results in optimized signal levels.
H) CHARGING THE RANDY III
1) USING THE AC POWER SUPPLY
1. Clip the home charger (C7) to the bottom of the unit in any side.
2. Connect the AC power supply (C6) to the home charger (C7).
3. Plug the AC power supply (C6) into a 220 V socket.
2) USING THE MOBILE CHARGE MODULE
1. Clip the mobile charge module (C8) to the bottom of the unit in
any side.
2. Plug the cigar lighter plug of the mobile charge module (C8) into
your vehicle.
- The charge begins.
mode and
-
disappears when the unit is fully charged.
3) CHANGING BATTERY PACK
The battery pack is pre-installed in the unit. If you need to replace
the battery pack :
(PTT + F)
" is displayed when the function is active.
appears on the display to indicate charging
indicates the charging level.
22