Fitting Instructions - R&G LP0175BK Instructions

FITTING INSTRUCTIONS


To fit the R&G tail tidy, remove the pillion seat or rear hump by removing the Torx bolt positioned
on the underside of the tail unit, as arrowed in picture 2 and shown removed in picture 1.

Lift the lever on the rear of the riders seat, gently pull rearwards and remove from the bike, as
shown in picture 3.

Remove the plastic cover above the ECU by unclipping the two prongs at the rear and the push
rivet at the front and then lift the ECU up to gain access to the wiring connectors, as shown in
picture 4.

Disconnect the rear wiring loom connector by squeezing the tabs on each side and gently pull off,
as shown in picture 5.

The rear wiring loom connector will remain attached to the ECU. This needs to be disconnected
from its mount, as shown in picture 6. To do this, it is advised to use a small screwdriver to push
the plastic prong sideward allowing the connector to slide off the mount.

Remove the four Torx bolts on the underside of the OEM licence plate hanger, as shown in picture
7.

The OEM licence plate hanger can now be removed from the bike. Gently lower it down onto the
rear tyre and feed the previously disconnected wiring connector through the rear subframe, as
shown in pictures 8 & 9.

With the OEM licence plate hanger off the bike, turn it upside down and remove the two Torx
bolts, as arrowed in picture 10 and remove the plastic cover on the underside, as shown in picture
11.

Disconnect the indicator connectors and cut the cable ties holding the wiring in place, as shown in
picture 11. It is a good idea to note which connector's match, to make re-fitting easier and mark
the indicators left & right. This is particularly important if using R&G Mini Indicators.

Remove the Torx bolt and nut on both indicators, and then twist the indicator mount to remove
from the mounting bracket, before feeding the wiring and connector out through the hole, as shown
in pictures 12 & 13.

On the back of the rear light mount there are three circlips which secure the rear light in place.
Remove these along with the three washers on the three mounting prongs, as shown in pictures 14
& 15.

Remove the tail light by sliding the unit out, releasing the prongs from the rubber mounts. Remove
the three rubber mounts from the plastic mount as they will be required when fitting the R&G Tail
Tidy, as shown in picture 16.

Take the mounting block (item 13 – M0393) and locate the two M6 x 25mm long cap head bolts
(item 11) through both counter bore holes in the side of the mounting block, as shown in picture
17.

Take the main bracket (item 9 – TB0160 Part 1) and attach this to the mounting block using the
two M5 x 16mm countersunk bolts (item 11), as shown in picture 18.

Take the licence plate bracket (item 7 – TB0160 Part 2) and attach this to the assembly using the
three M6 x 6mm long countersunk bolts (item 6) from the rear. This licence plate bracket has been
designed to accommodate a variety of styles of licence plate, and can be mounted horizontally or
vertically along with being spaced out wider in the horizontal format, as shown in pictures 19 &
20.

Fit the R&G license plate illuminator (item 2) to the assembly, as shown in picture 21. Use a small
amount of superglue to stick the light shroud in position. Fit one length of heatshrink to the wires
and tighten the nuts on the rear, as shown in picture 22.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
www.rg-racing.com Email: info@rg-racing.com