Push-To-Test Battery Meter - MINN KOTA Riptide Fortrex Manuel De L'utilisateur

1
a. First press the release button located on the left
underside of the pivot handle, then push the handle
down until you feel the handle "lock in" to the
stowed position. This will be almost parallel to the
motor shaft.
b. To extend the handle, pull the handle towards you to
the desired position. The handle will extend a full 6
inches. To retract, push the handle in until it
meets the face of the motor control head.
WARNING
The Riptide Fortrex is not intended to be a primary
propulsion motor. Heavy use of the motor can cause
elevated motor temperatures, which can be increased by
an excessively hot operating environment. Use care when
handling the control head to avoid burns or injuries from
excessive heat. In the event that the motor or speed control
would break, always be prepared to take manual control of
the boat.
Before attempting to put the handle in the stowed position, the speed selector must be in the OFF/STOW position. Failure to do so
will damage the internal mechanism.

PUSH-TO-TEST BATTERY METER

This motor is equipped with a "push-to-test" battery meter. The
LED light provides an accurate display of the remaining charge in
the battery. It is only accurate when the motor is off.
The meter reads as:
• One light indicates recharge.
• Two lights indicate low charge.
• Three lights indicate good charge.
• Four lights indicate full charge.
©2018 Johnson Outdoors Marine Electronics, Inc.
ADJUSTING THE DEPTH OF THE MOTOR
Handle Controls:
Off/On, Steering, and
Forward/Reverse
The position of the Tilt/Extend Tiller may create a pinch point
between it and the Control Head. Grasp the motor away from the
area that may come in contact with another area of the motor to
prevent injury.
CAUTION
WARNING
Release Button
Push-to-Test
Battery Meter
minnkotamotors.com | 23