MINN KOTA Riptide Fortrex Manuel De L'utilisateur page 12

INSTALLATION
2
c. Determine the desired orientation of the Stabilizer
Kit to attach it to the bottom of the Bowguard/
Steering Module.
NOTICE:
The kit can be installed on the left or right
side of the Bowguard.
d. Put the 5/16" Cap Screws through the Stabilizer
Bracket and the mounting holes on the Bowguard.
Secure the 5/16" Cap Screws with the 5/16-18
Nylock Nut. The Nylock Nuts fit into a hex pocket on
the inside of the Bowguard behind the spring. Secure
with a 1/4" Allen Wrench. Tighten to 10 ft lbs.
3
e. Measure the proper length of the Aluminum Rod by
standing it, with the threaded end down, onto the
deck surface so that it sits vertically right next to the
Stabilizer Bracket.
f. Mark the Aluminum Rod with a pencil or marker 3/4"
past the top of the Stabilizer Bracket.
CAUTION
Cutting the Aluminum Rod too short will cause inadequate
support of the mount. Lack of mount support may cause
damage.
g. Cut the Aluminum Rod with a Hack Saw at the
mark. Round the cut edge of the rod with a file or
sandpaper to remove any sharp edges.
12 | minnkotamotors.com
Bowguard
Cap Screw
Stabilizer
Bracket
Nylock Nut
Stabilizer
Bracket
Aluminum Rod
Jam Nut
©2018 Johnson Outdoors Marine Electronics, Inc.
3/4"