MINN KOTA Riptide Fortrex Manuel De L'utilisateur page 13

4
h. Replace the Bottom Bumper on the Aluminum Rod,
opposite from the threads.
i. Thread the Aluminum Rod into the Stabilizer Bracket
with the Bottom Bumper towards the boat deck.
j. Adjust the Aluminum Rod up or down in the
Stabilizer Bracket so that the Bottom Bumper just
touches the support surface. The Aluminum Rod
should have the ability to lift off the boat deck about
1/4" without the mount unlatching.
Adjusting the Aluminum Rod too tightly removes the end play needed for proper latch pin engagement and doing so could prevent
the mount from fully latching in the stowed position. Improper latching may cause damage. If installed correctly, the tip of the
Aluminum Rod should lift off of the boat deck about 1/4" without the mount unlatching.
5
k. Once in the correct position, tighten the Jam Nut
upwards against the Stabilizer Bracket. This will
prevent the Aluminum Rod from turning.
l. Install the Top Bumper if there are threads exposed
on the Aluminum Rod above the Stabilizer Bracket.
©2018 Johnson Outdoors Marine Electronics, Inc.
CAUTION
INSTALLATION
Stabilizer
Bracket
Jam Nut
Aluminum Rod
Bottom Bumper
1/4"
Top Bumper
Stabilizer
Bracket
Jam Nut
Aluminum Rod
minnkotamotors.com | 13