Stopping The Engine; Cutting Height - Stiga TURBO 55 COMBI Mode D'emploi

All manuals and user guides at all-guides.com
STARTING (Honda)
1. Place the lawnmower on flat, firm ground. Do
not start in long grass.
2. Make sure the spark plug cable is connected to
the spark plug.
3. Open the fuel tap (fig. 14).
4. Set the throttle control B in the choke posi-
tion . NOTE! It is not necessary to use the
choke position when the engine is warm (fig.
15).
5. Press the Start/Stop loopG towards the handle.
NOTE! The Start/Stop loopG must be kept
pressed in to prevent the engine stopping (fig.
15).
6. Grasp the starter handle and start the engine by
pulling briskly on the starter cord.
7. When the engine starts, move the throttle con-
trol backwards until max. revs are obtained.
NOTE! The engine should always be run at
maximum revs to avoid abnormal machine vi-
brations.
Keep hands and feet away from the ro-
tating blade(s). Never put your hand or
foot under the blade casing or in the
grass ejector while the engine is run-
ning.
STARTING (Honda/AVS)
1. Place the lawnmower on flat, firm ground. Do
not start in long grass.
2. Make sure the spark plug cable is connected to
the spark plug.
3. Open the fuel tap (fig. 14).
4. Move the automatic choke C to the choke posi-
tion . NOTE! It is not necessary to use the
choke position when the engine is warm (fig.
32).
5. Press down the Start/Stop loop G against the
handle and start the engine immediately by
pulling briskly on the starter cord.
NOTE! The automatic choke starts its return
movement when the Start/Stop loop G is
pressed down against the handle.
Keep hands and feet away from the ro-
tating blade(s). Never put your hand or
foot under the blade casing or in the
grass ejector while the engine is run-
ning.
ENGLISH

STOPPING THE ENGINE

The engine may be very warm immedi-
ately after it is shut off. Do not touch the
silencer, cylinder or cooling flanges.
This can cause burn injuries.
1. Release the Start/Stop loopG (fig. 15) to stop
the engine. This loop must not be disengaged
(e.g. by setting it in the depressed position
against the handle), as it will not be possible to
stop the engine.
Honda: Close the fuel tap.
2. If the lawnmower is left unattended, remove the
spark plug cable from the spark plug. Also re-
move the ignition key (*).
If the start/stop loop ceases to work, stop
the engine by removing the spark plug
cable from the spark plug. Immediately
take the lawn mower to an authorised
workshop for repair.
REAR WHEEL DRIVE (*)
Engage the drive by pressing the clutch loop I to-
wards the handle. Disengage the drive by releasing
the clutch loop I (fig. 15).
SPEED (*)
Do not touch the variator control when
the engine is not running. This can dam-
age the operation of the variator.
Set to a suitable speed by moving the variator con-
trol to one of the 4 positions (fig. 16).
The various positions have the following speeds:
Position :approx. 2.8 km/h
Position 2: approx. 3.1 km/h
Position 3: approx. 3.6 km/h
Position :approx. 4.5 km/h

CUTTING HEIGHT

Shut off the engine before adjusting the
cutting height.
Do not set the cutting height so low that
the blade(s) come into contact with une-
ven ground.
The mower has single-lever control for adjusting
the cutting height. Pull the lever out, and set the
cutting height to one of the nine positions best suit-
ed to your lawn (fig. 17).
GB
37