Checking The Engine Oil Level (21; 22); Checking The Transmission Fluid Level; Safety Checks; General Safety Check - Stiga Park 4WD Serie Manuel D'utilisation

EN
for which it is not possible to give precise indica-
tions regarding their use.
For further information it is advisable to consult the
instructions and data provided by the producer of
the alkylate-based petrol.
Never fill the tank right to the top.
Leave a little space (equal to at least the whole
depth of the top-up mouth + 1 - 2 cm from the top
of the tank) so that when the petrol heats up it has
room to expand without overflowing.
If you plan on putting the machine away
for a prolonged period (e.g. over the
winter), only put enough fuel in the tank
to finish the last job in hand.
In fact, before storing the machine it is
a good idea to empty the fuel tank com-
pletely (see 10).
7.4 CHECKING THE ENGINE OIL LEVEL
(21; 22)
The machine is delivered complete with engine oil.
Before starting the machine check the
level of the engine oil.
To check / top up the engine oil, see
9.5.1.
7.5 CHECKING THE TRANSMISSION FLUID
LEVEL
To check / top up the transmission fluid,
see 9.7.1.
7.6

SAFETY CHECKS

When trying out the machine, check that the
results of the safety checks correspond with the
indications provided in the following tables.
Always carry out the safety checks be-
fore use.
If any of the results fails to match the
indications provided in the following ta-
ble, do not use the machine!
Take it to a service centre to be checked and
repaired if necessary.
16
ENGLISH
(Translation of the Original Instructions)

7.6.1 General safety check

Object
Fuel lines and
connections.
Electrical cables
Exhaust system.
Oil lines
Drive the ma-
chine forwards/
backwards and
release the driving
pedal.
Test driving

7.6.2 Electrical safety check

Status
The parking
brake pedal is not
pressed.
Engine running.
7.7

START-UP / OPERATION

When using the machine, the bonnet
must be closed and fastened shut.
Always use full throttle when using the
machine.
When starting the machine, wait for
2 seconds in starting position before
starting the engine.
1. Open the fuel cock (24).
2. Check that the spark plug cables are instal-
led on the spark plugs.
3. Check the PTO is disengaged (11:D; 12:D).
4. Do not keep your foot on the service/drive
brake (10:F)
Models [B&S Power Built] [B&S Intek]:
Cold start
1. Engage the transmission (14:A1)
2. Activate the parking brake (10:B)
3. Put the choke on (11:A).
4. Turn the key in the ignition and start the en-
gine.
5. When the engine is running, gradually acce-
Result
No leaks.
All insulation intact.
No mechanical damage.
No leaks at connections. All
screws tightened.
No leaks. No damage.
The machine will stop.
No abnormal vibrations.
No abnormal sound.
Action Result
Try to start the The engine
machine. will not start.
The driver The engine
gets up from is switched
the seat. off.