Installing The Keypad; Default Configuration - Bodet Style 5S Hopital - NTP Notice D'installation Et De Mise En Service

2.2 Installing the keypad

To install and use the keypad (including in timer mode), refer to the instructions supplied with the
keypad.
III

– Default configuration

Restore factory settings by keeping the red button on the electronic board pressed until the clock
turns black.
Location of button on the electronic board:
The full factory configuration is as follows:
• IP configuration by DHCP (DHCP: ON)
• Time zone: EUR
• Synchronisation: Multicast
• Synchronisation address: 239.192.54.1
These four parameters are printed on the electronic board.
• Clock name: "BODET-@MAC"
• Pool period for unicast synchronisation: 15 mins.
• SNMP disabled
• Trap type: V2C
• Temperature alarm threshold: -5°C to +55°C
• Trap status issue period: 24 hr
• No password
• Luminosity: level 3
• 12 hr/24 hr mode: 24 hr
• Eco mode: Nor
• ON & OFF time: 23 hours OFF / 6 hours ON
On the electronic board connector:
Green LED: network activity + power supply
Yellow LED: network type (ON = 100 m, OFF = 10 m)
8
All manuals and user guides at all-guides.com
EN