I - Initial Verification; Unpacking The Clock; Backup - Bodet Cristalys 7 Instructions De Mise En Service Et D'utilisation

I - INITIAL VERIFICATION

Thank you for choosing a BODET clock. This product has been carefully designed for your
satisfaction based on ISO9001 quality requirements. We advise you to read this manual
thoroughly before attempting to manipulate the clock.
These indicate important comments.
Keep this booklet during all the life of your clock, so that you can refer to it each time it is
necessary.

1.1 Unpacking the clock

Unpack with caution and check the contents of the packaging. It must contain :
The Cristalys 7 clock clipped on to its wall holder,
For batteries version, 2 x 1,5 volt batteries, type LR 14,
A fixation kit (2 screws + 2 rawlplugs),
A cleaning kit (impregnated antistatic cloth)
This booklet,
with option, a table holder.
Remark : when unpacking, some segments of the clock can be activated. This is not a
default, insert the batteries, or connect the low voltage power supply and after a few seconds
the problem will disappear.
Versions : A descriptive label is fixed to the back of the clock :
IND QZ = the clock is independent.
RAD FI = the clock is radio-synchronised by a France Inter antenna.
RAD DCF = the clock is radio-synchronised by a DCF antenna.
AF/IMP PILE = the clock is receiving (driven by a master clock delivering
impulses, minute or 1/2 minute from 12 to 48V, on a parallel line, or coded time
AFNOR NFS-87500A).
AF/IMP +6/24V = the clock works similarly but is powered by an external power
supply delivering between 6 and 24V AC/DC.
RAD DHF = the clock is radio-synchronised by a DHF transmitter.
Bodet accepts no responsibility for accidents resulting from any use not conforming
with the above provisions.
Any modification to the product will invalidate the warrantee.

1.2 Backup

All the parameters for the clock are saved permanently even in the absence of power supply.
However, the date and time (time basis) are not saved by the clocks with batteries.
The clocks powered by external low voltage (+6/24V) keep their time bases during a few days
thanks to their internal battery.
21