I - Initial Verification; Unpacking The Clock; Backup - Bodet Cristalys Opalys 7 NTP Instructions De Mise En Service Et D'utilisation

TABLE OF CONTENTS ENGLISH TABLE OF CONTENTS ENGLISH TABLE OF CONTENTS

I - INITIAL VERIFICATION

I - INITIAL VERIFICATION
Thank you for choosing a BODET clock. This product has been carefully designed for your
satisfaction based on ISO9001 quality requirements. We advise you to read this manual
thoroughly before attempting to manipulate the clock. thoroughly before attempting to manipulate the clock.
These These indicate important comments.
Keep this booklet during all the life of your clock, so that you can refer to it each time it is
necessary.

1.1 Unpacking the clock

1.1 Unpacking the clock
Unpack with caution and check the contents of the packaging. It must contain :
The Cristalys or Opalys 7 clock clipped on to its wall holder,
A fi xation kit (2 screws + 2 rawlplugs),
A cleaning kit (impregnated antistatic cloth)
This booklet,
with option, a table holder.
Remark : when unpacking, some segments of the clock can be activated. This is not a default,
connect the power supply and after a few seconds the problem will disappear.
Versions : A descriptive label is fi xed to the back of the clock :
NTP PoE = the clock is confi gured as a receiver (controlled by a master clock sending SNTP
coded time messages, for example: Sigma Mod); it is powered by the network (Power over
Ethernet).
Bodet accepts no responsibility for accidents resulting from any use not conforming with
the above provisions.
Any modifi cation to the product will invalidate the warrantee.

1.2 Backup

1.2 Backup
All the parameters for the clock are saved permanently even in the absence of power supply.
18