I - Initial Verification; Unpacking The Clock; Backup - Bodet Cristalys Date Instructions De Mise En Service Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TABLE OF CONTENTS

I - INITIAL VERIFICATION

Thank you for choosing a BODET clock. This product has been carefully designed for your
satisfaction based on ISO9001 quality requirements. We advise you to read this manual
thoroughly before attempting to manipulate the clock.
These
indicate important comments.
Keep this booklet during all the life of your clock, so that you can refer to it each time it is necessary.

1.1 Unpacking the clock

Unpack with caution and check the contents of the packaging. It must contain :
- The Cristalys date clock clipped on to its wall holder,
- For batteries version, 4 x 1,5 volt batteries, type LR 14,
- A fixation kit (2 screws + 2 rawlplugs),
- A cleaning kit (impregnated antistatic cloth)
- This booklet,
- with option, a table holder.
Remark : when unpacking, some segments of the clock can be activated. This is not a default,
insert batteries, or connect the low voltage power supply and after a few seconds the problem
will disappear.
Versions : A descriptive label is fixed to the back of the clock :
IND QZ = the clock is independent.
RAD DCF = the clock is radio-synchronised by a DCF antenna.
AF/IMP PILE = the clock is receiving (driven by a master clock delivering impulses,
minute or 1/2 minute from 12 to 48V, on a parallel line, or coded time AFNOR NFS-
87500A).
AF/IMP +6/24V = the clock works similarly but is powered by an external power supply
delivering between 6 and 24V AC/DC.
RAD DHF = the clock is radio-synchronised by a DHF transmitter.
Bodet accepts no responsibility for any use not in compliance with these instructions.
Any modification to the product will invalidate the warrantee.

1.2 Backup

All the parameters for the clock are saved permanently even in the absence of batteries.
However, the date and time (time basis) are not saved in the absence of batteries.
The clocks powered by external low voltage (+6/24V) keep their time bases during a few days
thanks to their internal battery.
25

Publicité

Table des Matières
loading

Table des Matières