2.1.2 Mounting with back cover
According to the model of the clock make the cut-out following the dimensions listed in table below
Style 5S OP
Style 7S OP
Dimensions in mm
- Insert the back cover in the cut-out tn order to mark the position of the mountig screws.
a) Remove the back cover and drill 2 holes Ø 6 mm (
mounting
b) Drill 4 holes Ø 10mm (
c) Feed the power cable, the synchronisation cable and the keypad cable throught the cut-out and
cable glands of the back cover
d) Fix the back cover to the wall with the 2 screws Ø 4mm
e) Connect the clock, adjust the brightness (page 7) and set the time (refer to page 10)
f) Fix the clock to the back cover with the 4 screws Ø 4mm
6
All manuals and user guides at all-guides.com
A
B
400
46
440
) to make room for the back cover clock mounting rivets.
Y
Installation with the back cover
C
365
404
Y
X
Y
) to insert the wall plugs.for the back cover
X
Back cover mounting screws
D
E
68
107
85
123