I - Initial Checks; Unpacking The Clock; Cleaning - Bodet Style 5 Notice D'installation Et De Mise En Service

I – Initial checks
Thank you for choosing a BODET clock.
This product has been carefully designed, adhering to ISO 9001 quality processes, to ensure your
satisfaction. We recommend that you read this manual and the general safety measures and
operating instructions carefully before handling the clock.
Retain this manual for reference for the lifespan of your clock.
The information supplied is non-binding; Bodet reserves the right to make changes to equipment,
including functional, technical and aesthetic changes or changes to colours, without notice.
Failure to observe these instructions may cause irreversible damage to the clock and
invalidate the warranty.
These instructions relate to the following clocks:
Style 5: hours and minutes display. Height of digits: 5 cm.
Style 5S (seconds): hours, minutes and seconds display. Height of digits: 5 cm.
Style 7: hours and minutes display. Height of digits: 7 cm.
Style 7D (date): hours, minutes, date, day and week display. Height of digits: 7 cm; height of
letters: 5cm.
Style 7E (ellipse): hours, minutes and revolving seconds display on ellipse design. Height of
digits: 7 cm.
Style 10: hours and minutes display. Height of digits 10 cm.
Style 10S (seconds): hours, minutes and seconds display. Height of digits: 10 cm.
These instructions relate to synchronisation of the clocks as follows:
IND (independent) - IMP (impulse): The clock should be configured independently, or as part
of a time distribution network, driven by a master clock which sends out impulses (independent,
minute or half minute in parallel).
RADIO (FI + DCF): The clock may be configured independently or radio-synchronised using an
external France Inter or DCF or GPS antenna (optional product not included).
DHF: The clock is radio-synchronised by a DHF radio signal.
AFNOR: The clock should be installed as part of a wired coded time distribution network in
compliance with AFNOR or IRIG-B standards.

1.1 Unpacking the clock

Carefully unpack the clock and check the contents of the package. This should include:
• Style clock
• 3 screws (Ø4mm)
• Anti-static cleaning kit
• Manual
• IMPORTANT: product identification label
An identification label is affixed to the back of the clock. Use the URL link shown to download these
instructions from the Bodet website: www.bodet-time.com.

1.2 Cleaning

Use an anti-static product identical to that in the cleaning kit provided.
Never use alcohol, acetone or other solvents, which may damage your clock's casing or glass.
4
All manuals and user guides at all-guides.com
EN