I - Initial Verification; Unpacking The Clock; Backup - Bodet Cristalys Opalys 7 NTP Instructions De Mise En Service Et D'utilisation

I - INITIAL VERIFICATION

Thank you for choosing a BODET clock. This product has been carefully designed for your
satisfaction based on ISO9001 quality requirements. We advise you to read this manual
thoroughly before attempting to manipulate the clock.
These indicate important comments.
Keep this booklet during all the life of your clock, so that you can refer to it each time it is
necessary.

1.1 Unpacking the clock

Unpack with caution and check the contents of the packaging. It must contain :
The Cristalys or Opalys 7 clock clipped on to its wall holder,
A fixation kit (2 screws + 2 rawlplugs),
A cleaning kit (impregnated antistatic cloth)
This booklet,
with option, a table holder.
Remark : when unpacking, some segments of the clock can be activated. This is not a
default, connect the power supply and after a few seconds the problem will disappear.
Versions : A descriptive label is fixed to the back of the clock :
NTP PoE = the clock is configured as a receiver (controlled by a master clock
sending SNTP coded time messages, for example: Sigma Mod); it is powered by
the network (Power over Ethernet).
Bodet accepts no responsibility for accidents resulting from any use not conforming
with the above provisions.
Any modification to the product will invalidate the warrantee.

1.2 Backup

All the parameters for the clock are saved permanently even in the absence of power supply.
19