I - Initial Verification; Unpacking The Clock - Bodet Cristalys 7 Instructions De Mise En Service Et D'utilisation

TABLE OF CONTENTS

I - INITIAL VERIFICATION

Thank you for choosing a BODET clock. This product has been carefully designed for your
satisfaction based on ISO9001 quality requirements. We advise you to read this manual
thoroughly before attempting to manipulate the clock.
The installation and the maintenance service of this clock has to be done by skilled person.
These indicate important comments.
Keep this booklet during all the life of your clock, so that you can refer to it each time it is
necessary.

1.1 Unpacking the clock

Unpack with caution and check the contents of the packaging. It must contain :
- The Cristalys 7 clock clipped on to its wall holder,
- For batteries version, 2 x 1,5 volt batteries, type LR 14,
- A fixation kit (2 screws + 2 rawlplugs),
- A cleaning kit (impregnated antistatic cloth),
- with option, a table holder.
- This booklet..
Remark : when unpacking, some segments of the clock can be activated. This is not
a default, insert the batteries, or connect the low voltage power supply and after a few
seconds the problem will disappear.
Versions : A descriptive label is fixed to the back of the clock :
RAD DCF = the clock is radio-synchronised by a DCF antenna.
AF/IMP PILE = the clock is receiving (driven by a master clock delivering impulses,
minute or 1/2 minute from 12 to 48V, on a parallel line, or coded time AFNOR NFS-
87500A).
AF/IMP +6/24V = the clock works similarly but is powered by an external power
supply delivering between 6 and 24V AC/DC.
RAD DHF = the clock is radio-synchronised by a DHF transmitter.
Bodet accepts no responsibility for accidents resulting from any use not conforming with
the above provisions.
Any modification to the product will invalidate the warrantee.
21