Safety Information; Installing The Product - Bodet Profil 750 Guide De Démarrage Rapide

Guide de démarrage rapide - Quick start guide - Schnellstartanleitung - Guía de inicio rápido

SAFETY INFORMATION

We recommend that you read this manual carefully before installing the product.
Failure to observe these instructions may cause irreversible damage and invalidate the warranty.
BODET shall not be responsible for any damage arising due to non-observance of these instructions.
Identification of pictograms :
Symbol Description
IEC60417 - 1641
Operating instructions
IEC60417 - 5019
Protective earth (ground)
IEC60417 - 5032
Alternating current
IEC60417 - 6041
Caution, visible radiation
IEC60417 - 6042
Caution, risk of electric shock
IEC60417 - 5002
Positioning of cell

INSTALLING THE PRODUCT

This equipment must be fitted and maintained by a qualified person.
Electrical installation :
The clock must be powered through the building's electrical installation. It is designed for Category II overvoltage. Max. V peak: 2500V.
Provide a mains power supply protection compliant with CEI 61643 in other cases, if necessary. The electrical installation of this
equipment must comply with the rules laid down in the standards in force in the country where the product is used.
The installation must comply with the IEC 364 standard or with the 802.3af, class 3 standard (for PoE power supply).
Provide a differential circuit breaker max. 30mA / phase-neutral of 16A maximum, rapidly accessible upstream from each power-supply
line (permanent power supply for the clock and power supply for the lighting according to your model).
This circuit breaker provides power supply protection and disconnecting, and must be cut off in the event of maintenance.
Conductors on the same circuit must be attached to each other close to the terminal block to avoid reduced isolation should one of the
terminals become loose.
Attach the cables connected to the clock terminal block on the fixing plate (single-sided model) or on the central bracket (double-sided
model) with cable retainers to avoid pulling on the terminal block.
The equipment should not be powered up until it has been mounted to the wall. The clock must be closed.
Moreover, with lighting option, if the clock is open and switched on, there is a danger of light radiation for eyes.
Depending on the options chosen, your clock may be fitted with an emergency battery. There is risk of explosion if the
battery is replaced by a battery of incorrect type. Dispose of used batteries according to the manufacturer's instructions.
Mechanical installation :
The clocks can be installed outside.
The wall fixings must be suitable for the type of wall where the clock is mounted :
- For wall-mounted singled-sided clocks, each of the three screws must be able to withstand a tensile strength of 30 kg,
- For double-sided clocks, each of the four M8 screws must be able to withstand a tensile strength of : 270 kg (Profil 780) or 150 kg
(Profil 750 or Profil 760).
Opening the clock :
Opening the product for maintenance operations is allowed, only by a qualified person :
Caution, risk of electric shock. Disconnect all power sources.
Ensure that all power supply sources are removed from the clock before performing maintenance operations.
>> www.bodet-time.com <<
Profil 750 - 760 - 780
Document non contractuel. © 2022, Bodet Time & Sport . Tous droits réservés.
2
IEC60417 - 6172
Disconnection, all power plugs
IEC60417 - 0434b
Caution
IEC60417 - 5012
Control of lighting and light sources
IEC60417 - 5184
Control related to clock, time and timers
IEC60417 - 6414
Waste Electrical and Electronic Equipment
(WEEE)
Documentation technique disponible sur www.bodet-time.com
EN