Transport - Hilti VC 40 Mode D'emploi

3. Remove the accessories and packaging from the
waste material container.
NOTE Use the class M version for picking up dusts
with an exposure limit value of ≧ 0.1 mg/m³. Fit a
filter fleece or plastic dust bag for mineral dust or a
paper dust bag for wood chips or shavings in the
container in accordance with the instructions.
NOTE When used to pick up harmless dusts: Fit a
en
plastic dust bag in the container in accordance with
the instructions (see printed instructions).
4. Fit the vacuum cleaner top section onto the waste
material container.
5. Close the two catches.
6. Check to ensure that the vacuum cleaner top section
is fitted correctly and secured.
7. Connect the suction hose to the appliance.
6.2.1 Fitting a paper dust bag for picking up wood
chips or shavings 3
1. Open the two catches.
2. Lift the vacuum cleaner top section away from the
waste material container.
3. Place the new paper dust bag in the waste material
container.
4. Fit the vacuum cleaner top section onto the waste
material container.
5. Close the two catches.
6. Check to ensure that the vacuum cleaner top section
is fitted correctly and secured.
7. Connect the suction hose to the appliance.
7 Operation
WARNING
For vacuum cleaners of the class M, please note: Va-
cuum off the outer surfaces of the appliance, wipe
it clean or seal it in a suitable container or mater-
ial before removing it from an area contaminated
with hazardous substances. All parts of the appliance
must be regarded as being contaminated when they
are removed from the hazardous area and suitable
measures must be taken to avoid spreading dust.
WARNING
In an emergency (e.g. burst filter), switch the appli-
ance off, disconnect it from the electric supply and
have it checked by a trained specialist before further
use.
CAUTION
For vacuum cleaners of the class M, please note: CAU-
TION: This appliance contains harmful dust. The va-
cuum cleaner may be emptied (including disposal of
the dust container) or serviced only by trained per-
sons wearing the appropriate protective equipment.
Do not operate the appliance if the filter system is
incomplete.
24
All manuals and user guides at all-guides.com
6.3 Power conditioner
CAUTION
When placing the power conditioner in the cradle
check that the power outlet faces upwards and the
spring catch engages.
CAUTION
To avoid injury, remove the power conditioner and any
loose accessories from their attachment points be-
fore emptying the container and before transporting
the vacuum cleaner.

6.4 Transport

DANGER
With vacuum cleaners of the class M, take care to
ensure that the hose socket cap is fitted when the
appliance is transported or not in use.
DANGER
The appliance may be moved or transported only
when the motor has come to a complete stop.
Do not carry the appliance when it is full of waste material.
Empty the appliance before carrying it to another location.
Do not tip the appliance or lay it on its side for transport
after using it to collect water.
The tapered adapter can be used to connect both ends
of the hose together for transport.
CAUTION
Always check to ensure that the vacuum cleaner is
standing securely. Engage the castor brakes.
7.1 Hose diameter setting (VC 20‑UM/ VC 40‑UM)
When picking up dry, non flammable dust which has an
exposure limit value, or when picking up wood chips or
shavings, adjust the hose diameter setting switch to the
correct diameter setting for the suction hose used. When
using the appliance in conjunction with the Hilti hollow
drill bit system, set it to the smallest hose diameter.
See
(VC 20‑UM/ VC 40‑UM)
7.2 Operation without use of the electric tool
NOTE
Check that the appliance is switched off before plugging
it into the power outlet (control switch in the "OFF"
position).
1.
section: 2.2 Hose
power outlet
Plug the supply cord into the power outlet.
diameter settings