Deltaplus Speed Line LV201 Notice D'utilisation page 13

Follow step by step the instructions and recommendations of the manufacturer in order to guarantee a suitable
installation.
Use the appropriate tools for the described actions which do not damage the device.
Choose a strong structure, minimum 13kN. The user must ensure that the support materials in which the structural
anchor devices are attached are adapted for this constraint.
WARNING:
The attachment point must be located above the user and the work carried out in such a way, as to minimise both
the potential for falls and potential fall distance and it must have a minimum resistance of 13kN according to EN795
& CENTS 16415:2013.
RECOMMENDATIONS:
For safety reasons and before each use, check:
- that the anchorage complies to the instructions
- that the anchorage is appropriately installed
- that the device does not show any sign of corrosion
- that the yearly control of the device is still valid
- that the operating instructions described for each component of the system are met; equipment shall not be used
outside its limitations or for any purpose other than that for which it is designed.
- that the general disposition of the work situation reduces the fall risk, the drop height and the pendulum
movement in the case of a fall.
- the vertical clearance is sufficient (free space beneath the feet of the user) and no obstacles disrupt the normal
functioning of the fall arrest system.
The vertical clearance is the stopping distance H + additional safety distance of 1 m. The distance H measured from
the initial position to the final position (user's balance after the fall arrest).
Check that there is enough height below the user according to the equipment used.
A height of 2m minimum must be left below the user's feet.
Check that the overall layout restricts swinging to a minimum if a fall should occur. It is essential for safety to verify
the free space required beneath the user at the workplace before each occasion of use, so that, in the case of a fall,
there will be no collision with the ground or other obstacle in the fall path.
WARNING:
Under no circumstances should the user open, adjust or operate the equipment when using the LV201
These manipulations can be performed only when the risk of falling is avoided.
Before each use, check that the anchor is securely fixed on its support.
Any check or inspection of an anchoring device must be made when the user is safely anchored on another
anchoring device that has been already checked and validated.
This equipment should be operated only by trained, competent and in good health people, or under the
supervision of a trained and competent person.
In case of doubt on the status of the device (traces of oxidation) or after a fall (deformation), it should not be
reused and / or be returned to the manufacturer or a competent person mandated by them.
It is forbidden to remove, add or replace any component of the anchor without the agreement of the
manufacturer.
Temperature: LV201 should be used in work environments with minimum temperatures of -40°C / maximum of
+50°C.
Chemicals: Put the equipment out of service in the case of contact with chemicals, solvents or fuels that could
affect the operation.
WARNING:
The user's safety depends on the continuing efficacy of the PPE, its strength and the proper understanding of the
instructions in this manual.
WARNING: Any static or dynamic overload may damage the PPE.
The device may only be used by one person at a time, according to EN795. This device has been tested to be used
up to 2 users simultaneously, according to CENTS 16415 type B+C (HYBRID).
The weight of the user, including his clothing and equipment must not exceed the maximum weight of a person
(100kg according to fall arrest standards).
The weight of the users including their clothes and equipment must not exceed the maximum weight of 2 persons
(200 kg according to fall arrest standards).
WARNING:
It is dangerous to create your own fall arrest system as each safety function may interfere with another safety
function.
LV201 Anchorage device UPDATE : 30.06.2016 13/92
B.P. 140 - ZAC de La Peyrolière
84405 APT CEDEX - FRANCE