Monogram ZGP304N Manuel Du Propriétaire page 39

PROBLEM
TIMER DOES NOT
WORK
OVEN TEMPERATURE
TOO HOT OR TOO
COLD
OVEN DOOR WILL NOT
OPEN AFTER A CLEAN
CYCLE
"Err turn SurFACE
BurnErS OFF" SCROLLS
IN THE DISPLAY
"CLOSE door"
SCROLLS IN THE
DISPLAY
IS ON WHEN YOU
WANT TO COOK
F- AND A NUMBER
FLASH IN THE DISPLAY
DISPLAY GOES BLANK
UNABLE TO GET THE
DISPLAY TO SHOW
"SF"
"PROBE" APPEARS IN
THE DISPLAY
SHOWS IN DISPLAY
POWER OUTAGE
STEAM FROM THE
VENT
BURNING OR OILY
ODOR EMITTING FROM
THE VENT
STRONG ODOR
FAN NOISE
POSSIBLE CAUSE
The timer cannot be used while the oven is self-cleaning.
Oven thermostat needs adjustment. See the Oven thermostat adjustment
section.
The oven is too hot. Allow the oven to cool below locking temperature.
Self-clean is in progress and the Cooktop Lockout feature is activated. No
surface cooking is permitted during the self-clean operation. Wait until the self-
cleaning operation has been completed.
The self-clean cycle has been selected but the door is not closed.
Close the oven door. The
The oven door is locked because the temperature inside the oven has not
dropped below the unlocking temperature. Turn the Oven Mode Selector and
the Temperature knobs to OFF. Allow the oven to cool.
The oven has a function error code. Turn the Oven Mode Selector and the
Temperature knobs to OFF. Allow the oven to cool for one hour. Put the oven
back into operation.
Disconnect all power to the oven for 30 seconds and then reconnect power. If
the function error code repeats, call for service.
The display is blank when the oven or timer is not in use.
A fuse in your home may be blown or the circuit breaker tripped. Replace the
fuse or reset the circuit breaker.
The TIMER and the MINI-KNOB buttons must be pushed at the same time and
held for 4 seconds.
This is reminding you to enter a probe temperature after plugging in the probe.
Enter a probe temperature
The Sabbath mode has been selected.
If the oven was in use during a power outage or surge, the oven must be reset.
Turn the Temperature knob and the Oven Mode Selector to OFF. Reset the
controls to begin again.
When using the convection mode, it is normal to see steam coming out of the
oven vent. As the number of racks or amount of food being cooked increases,
the amount of visible steam will increase.
This is normal in a new oven and will disappear in time.
This is temporary. An odor from the insulation around the inside of the oven is
normal for the first few times the oven is used.
A cooling fan or a convection fan (depending on the function you are using)
may turn on. This is normal. The cooling fan will turn on to cool internal parts. It
may run after the oven is turned off. The convection fan may cycle on and off
until the function is over or the door is opened.
The Problem Solver
Professional All-Gas Range
symbol will appear in the display
39