Installation And Electrical Connection; Installation Of The Motor Into A Shaft - Selve SEL Plus Notice De Réglage

Installation and electrical connection

3. Installation and electrical connection
Caution! Risk of injury through an electric shock!
Connection only when de-energised!
Run the motor only after installation.
Warning!

3.1. Installation of the motor into a shaft

1. Attach crown and coupling adapter to the motor and fasten them
with the locking device.
2. Push the motor into the shaft in a positive-locking way. The motor must not be
subject to any impacts. Crown and coupling adapters must not have any play
inside the shaft.
3. Where required, secure the motor axially, e.g. by screwing the shaft
to the coupling adapter. Do not drill holes into the motor area!
4. Attach the shaft with the motor and the shaft cap in the bearings. Do not bend
the motor cable and place it so that it cannot be damaged. To keep water from
getting into the motor, place the motor line in a bend direction downwards, so
that any water can drip off.
5. Attach the curtain to the shaft.
23
GB
GB