Designated Use; Installation And Electrical Connection; Installation Of The Motor Into A Shaft; Supporting The Motors - Selve SP 2/15 Notice D'emploi

EN Installation and electrical connection

2. Designated use

The motor types SP must only be used for operating roller shutters, awnings and (zip­)
screens.

3. Installation and electrical connection

3.1. Installation of the motor into a shaft

1. Attach crown and coupling adapter to the motor and
fasten them with the locking device.
2. Push the motor into the shaft in a positive­locking way. The motor must not be
subject to any impacts. Crown and coupling adapters must not have any play
inside the shaft.
3. Where required, secure the motor axially, e.g. by screwing the shaft
to the coupling adapter. Do not drill holes into the motor area!
4. Attach the shaft with the motor and the shaft cap in the bearings. Do not bend
the motor cable and place it so that the motor cable cannot be damaged. To
keep water from getting into the motor, place the motor line in a bend direction
downwards, so that any water can drip off.
5. Attach the curtain to the shaft.

3.2. Supporting the motors

In general, SELVE motors can be supported by means of an inserted square or by
means of the external contour of the motor head. There are different motor brackets for
all support options.
Furthermore, different flanges or mounting plates can be pre­screwed. In case of
square support, there must be a mechanical stop behind the motor bearing, in order
to avoid axial movement of the square.
16