CAMPAGNOLA STARK 90 Manuel D'utilisation Et D'entretien page 31

Stopping the tool
The shear must be switched off and the blades must be closed at the end of the work session. Therefore:
1) Keep the trigger (4) pressed for five seconds until you hear a beep. The blades close and remain closed. Release
the trigger.
2) Put the ON/OFF button (5) in "off" position
3) Remove the battery (9).
Take care in storing the tool and the battery (9) away from heat, dust and humidity.
Storing the tool
• Keep the trigger (4) pressed for five seconds until you hear a beep. The blades close and remain closed. Release
the trigger (4).
• Switch the tool off and remove the battery (9).
• To preserve the lifespan of the batteries and prevent them from deterioration, they must be stored charged and they
must be recharged every 3 months, if they are not used.
• Clean and lubricate the tool before storing it together with its components away from heat, dust and humidity.
• Store the battery (9) in a dry place with a temperature between 0 ° C and + 25 ° C.
Troubleshooting
WARNING!
All extraordinary maintenance operations must be carried out by a mechanical or electrical / elec-
tronic maintenance technician.
FAULT
The tool cannot complete the cut.
The battery (9) does not get com-
pletely recharged.
Electric/mechanical wrong functio-
ning.
The tool does not work.
ATTENZIONE!
Neglecting the instructions in the manual could cause damages or injuries.
Use and maintenance manual – Translation of
original Instruction.: 00, Date 07/06/2021
CAUSE
The branch diameter is over 25 mm or
the wood is too hard.
• Damaged battery (9).
• Faulty battery charger (11).
• Unsuitable battery charger (11).
• Motor overheating.
• The tool makes noise.
Possible electronic or mechanical
problem.
REMEDY
Immediately release the trigger (4).
The cutting blade (1) will go back to its
opening position.
• Check that the battery charger (11)is
the one supplied with the tool.
• Replace the battery (9).
• Replace the battery charger (11).
Contact an Authorized Service Point.
Contact an Authorized Service Point.
Page 31