Publicité
Les langues disponibles
Les langues disponibles
Each recharge connector (13) has a corresponding indicator on the battery charger.
The batteries are charged in sequence, the one after the other, not simultaneously.
Charge with 3 batteries: Picture 1 = Recharge in progress
Picture 3 = Recharge completed
Picture 3
Important: When two or three batteries are connected to the battery charger, they will be charged in sequence, start-
ing from no. 1, followed by no. 2 and then by no. 3. The LED light becomes red while recharging, green when re-
charge is over. As soon as the first battery (9) is charged up (green LED light), the recharge of the second battery will
start, then of the third one, if they are all connected to the battery charger.
WARNING!
During long periods of inactivity of the tool, it is recommended to charge the batteries every 3 months, so as
not to compromise their lifespan.
WARNING!
Use only the charger supplied (11) with the tool. A model with different specifications could cause fires.
Warnings during and after the charge
•
While recharging, the charger and the battery (9) become warm.
•
About 5 charging and discharging cycles are necessary to make a battery reach its maximum capacity, if it is new
or if it has not been used for a long period.
•
Do not charge the batter (9) at a room temperature below 0°C (32°F) or above 45°C (113°F).
•
Do not recharge a previously charged battery after few minutes of use, so as not to reduce its performance.
•
Do not use a damaged battery.
•
Do not disassemble either the battery (9) or the battery charger (11).
•
When the battery (9) is not connected to the tool, keep it away from conductive metal objects, in order to avoid short
circuit risks.
•
Do not cause a short circuit of the battery (9).
•
Do not store the battery (9) near heat sources, indoors or in a potentially explosive atmoshere. The battery could
explode or generate a fire.
•
Do not charge the battery (9) in damp rooms or outdoors.
•
Do not use or charge the battery (9) close to heat sources or in the direct sunlight.
•
When the battery (9) charge decreases, also the tool cutting performance decreases.
•
Do not leave the battery (9) in the rain and store it in a dry place.
•
Do not put the tool, the battery (9) or the charger into any liquids.
•
Do not insert nails, do not hammer or step on or throw or cause any other damage to the battery.
•
Do not carry out welding on the battery.
Use and maintenance manual – Translation of
original Instruction.: 00, Date 07/06/2021
Picture 1
Page 29
Publicité
