Publicité
Les langues disponibles
Les langues disponibles
•
Do not reverse the polarity of the connections or excessively discharge the battery.
•
Do not connect the battery (9) to car chargers or cigarette lighter sockets.
•
Do not use the battery (9) for devices which are other than those indicated by the Manufacturer.
•
Do not come into direct contact with lithium battery cells.
•
Do not put the battery (9) into microwaves or containers with high temperatures or high pressures.
•
Do not use the battery (9) in case of fluid loss.
•
Do not use the battery (9) in an electrostatic environment (above 64 V)
•
Do not use the battery (9) if it is corroded, visibly deformed or unpleasantly smelly.
•
If your skin or clothes come in contact with the battery fluid, rinse them immediately with water.
•
Keep the battery (9) fully charged when the tool is not used for long periods.
•
Always disconnect the charger from the electrical network, when the batteries are charged up.
•
Always disconnect the batteries from the charger (11) after recharging.
Packing and transport
The unit is packaged by the Manufacturer and sent to the dealer in a carton box.
WARNING!
The handling of loads must be carried out in compliance with the current workplace safety rules. Use the box
for storing the tool for medium or long periods or for sending the packed product to a Service Point for repairs.
Tool starting
Before operating the tool, always wear protective clothing.
•
Hold the handle with one hand. With the other one press the ON/OFF button (5).
•
The tool is ready for use.
WARNING!
•
Use the tool only for the purposes described in par. "Product description". Any other use could cause inju-
ries.
•
Operate the tool only when it is among the branches. Any improper use causes greater tool wear and battery
consumption.
Precautions for the use
•
Do not cut either branches with a diameter over 38 mm, or metals, stones or any object which is not a plant. When
the blades get worn or damaged, replace them.
•
Rinse the tool by means of a clean and dry cloth. Do not use any petrol or solvents.
•
To rinse the tool, do not use degreasers which are abrasive or contain solvents.
•
For a proper tool operation follow the instructions. In case of damage do not use the tool, the battery (9) and its
charger.
•
Do not use the tool when it does not work properly.
•
Always remove the battery (9) before any operation of adjustment or part replacement or before storing it at the end
of the work session. This allows to reduce the residual risks due to an involuntary tool activation.
•
The blades must be closed when the shear does not work.
•
The tool must be operated following the instructions and the way of use indicated in this manual, taking into con-
sideration the environment and the kind of work to carry out. It is recommended not to use the tool in case of poor
psychophysical skills or in situations which are different from the indicated ones, as it could be very dangerous.
•
After each use remove the residues from the blades by means of LUBE SPRAY GREASE lubricant, recommended
by the Manufacturer. These operations guarantee that the blades are kept in good conditions, reduce wear and
extend the lifespan of the tool, as well as of the blades.
Pag. 30
Use and maintenance manual – Translation of
original Instruction.: 00, Date 07/06/2021
Publicité
