Publicité
Les langues disponibles
Les langues disponibles
Tool starting
1)
Plug the battery (9) into its seat under the handle.
2)
Switch the tool on by pressing the ON/OFF button (5). After a long beep followed by a short one, the LED indicator
(6) turns on.
3)
Press the trigger (4) two times. The blades will open automatically.
In case of failure, the blades will not open. Store the tool and contact an Authorized Service Point.
Normal pruning: Press the trigger (4) to close the blades and release it to open them again.
4)
Blade group closing position: keep the trigger (4) pressed for five seconds until you hear a beep. The blades will
close and remain closed. Release the trigger (4).
•
In order to check the shear for proper functioning, before using it, press and release the trigger (4) without carrying
out cuts, to close and open the blades. Repeat the operation more times.
•
If not used, the tool will automatically switch off after 5 minutes.
WARNING!
It is recommended to close the blades, when the tool is not in use.
WARNING!
Do not work on trees or stairs, as it is extremely dangerous.
Before starting to work with the tool, wear suitable protective clothing.
Battery charging
Connect the battery (9) to the battery charger (11) (picture 1) and the plug of the charger to the socket. Avoid using
electrical extension cables, as they are a source of electrical risks. The battery charger (11) LED light (12) becomes
red while charging. When the battery (9) is charged up, the LED light (12) becomes green.
Pag. 28
Use and maintenance manual – Translation of
original Instruction.: 00, Date 07/06/2021
Publicité
