Könner & Söhnen KS 2100i S Mode D'emploi page 25

Level check
Motor oil
Replacement
Check /Cleaning
Air filter
Replacement
Cleaning
Spark plug
Replacement
Level check
Fuel tank
Cleaning
Fuel filter
Check (clean out)
- If the generator often operates at high temperature or high load, the oil should be replaced every 25 operating hours.
- If the engine often runs in dusty or other harsh conditions, clean the air filter every 10 operating hours.
- If you missed the maintenance time, perform it as soon as possible to save the generator engine.
IMPORTANT!
Use oils designed for four-stroke cycle vehicle engines SAE10W-30,
SAE10W-40. Motor oils with other viscosity levels, may be used only if the
average air temperature in your region does not exceed the limits of the
temperature range, specified in the table.
Upon oil level decrease it is necessary to add the required quantity in order to provide the correct generator operation. It is necessary to
check the oil levels according to technical maintanance schedule. Further details can be found in the full version of the manual on our
website.
Air filter cleaning is to be performed each 50 hours of the generator operation (every 10 hours in unusually dusty conditions).
CLEANING THE FILTER: CLEANING THE FILTER:
1. Open the clips on the upper cap of the air filter.
2. Remove the sponge filtering element.
3. Remove all dirt deposits inside the hollow case of the air filter.
4. Thoroughly wash the filtering element in warmsoapy water.
5. Dry the sponge filter.
6. Dry filtering element is to be moistened by motor oil and excess oil is to be squeezed out.
Spark plug has to be intact, without soot deposits and to have a correct gap.
SPARK PLUG VERIFICATION: SPARK PLUG VERIFICATION:
1. Remove the cap from the spark plug.
2. Remove the spark plug by means of a corresponding spanner.
3. Examine the spark plug. If is is shattered – it is necessary to replace it.
Recommended replacement spark plugs – A5 RTC. For moddels KS 5500iES ATSR, KS 5500iEG S - A7 RTC.
4. Measure the gap. It has to be within range 0.7-0.8 mm.
5. In case of repeated use, the spark plug has to be cleaned by means of a metal brush. After that – set the correct gap.
TECHNICAL MAINTENANCE WORKS
The manufacturer shall not be liable for any damage caused by failure
to perform maintenance work.
AIR FILTER TECHNICAL MAINTENANCE
SPARK PLUGS TECHNICAL MAINTENANCE
RECOMMENDED OILS
10W-30, 10W-40
-20 -20 -10 -10 10 10
0
www.ks-power.de/en
10
C C
20 20 30 30 40 40 0 0
11
12
| 24