Berkel BV 400/25 Mode D'emploi page 25

2 SwITCHINg oN
the display shows the initials of the options available for three seconds; this is followed by display of the
program number set in the top quadrant and eventual functions activated in the bottom quadrant (V=JARS;
G=GAS).
3
PrograM SElECTIoN: Select the program (from 0 to 9) using the keys
4
SElECTINg THE vaC fuNCTIoN: Select the vaC function by means of key SEl
5
PrograMMINg THE vaC fuNCTIoN: Enter the program by pressing Prog
start flashing. Set the required value expressed in seconds using the keys
or proceed with programming the successive functions by pressing SEl
5
6
SElECTINg THE gaS fuNCTIoN (oPTIoNal): Select the gaS function by means of SEl
7
PrograMMINg THE gaS fuNCTIoN: The digits on the display start flashing. Set the required value
using the keys . Confirm by means of Prog
4
by pressing SEl
6
8
SElECTINg THE SEal fuNCTIoN: Select the SEal function by means of SEl
9
PrograMMINg THE SEal fuNCTIoN: The digits on the display start flashing. Set the required value
using the keys . Confirm by means of Prog
4
by pressing SEl
6
10
CoNfIrMINg THE PrograMMINg: There are three ways to confirm the program set:
• press Prog ;
5
• press SEl until the program number reappears and the display stops flashing;
6
• wait for about seven seconds without pressing any key.
It is now possible to proceed with other program settings, or proceed with packaging.
11
STarTINg uP THE work CyClE: using both hands lower the lid, pressing down lightly at the corners.
The appliance will start the work cycle in accordance with the set parameters.
12
work CyClE ENd: The appliance ends the cycle automatically after the sealing bar cooling, with air re-
entering the chamber resulting in opening of the lid. Remove the packed product and check the bag seal: it
must be uniform, clearly marked without melted points. If necessary, adjust the preset values and proceed
with the second cycle.
Instruction manual for vacuum chamber packaging machines Mod. BV 400/25 – BV 400/25H – BV 600/60
Rev. 01 - 04/2019 - Cod. 1500656 - Instruction manual for vacuum chamber packaging machines Mod. C46-C46H-C62
5
5
PROG
4
4
: Turn On the main switch
.
. For bags with basic weight 90/100, set the value as 2.2 ÷ 3 seconds.
Instruction manual for vacuum chamber packaging machines Mod. BV 400/25 - BV 600/60
6
6
PUMP
SEL STOP
on the control panel; the LED in the switch lights up;
2
or proceed with programming the successive functions
5
or proceed with programming the successive functions
5
4
.
6
.
: the digits on the display
5
. Confirm by means of Prog
4
6
.
6
.
6
.
2
25