Berkel BV 400/25 Mode D'emploi page 23

warNINg! the appliance has two basic programs (models without gas option) or three basic
programs (models with gas option) that are factory-set. The user must proceed with program-
ming the remaining programs according to his operating requirements, depending on the type
and quantity of product to be packed.
BaSIC FUNCTIONS PROgRaMMINg (vaCUUM PaCKINg aND Bag SealINg)
1 SwITCHINg oN
lights up; the display shows the initials of the options available for three seconds; this is followed
by display of the program number set in the top quadrant and eventual functions activated in
the bottom quadrant. (V=JARS; G=GAS).
2
PrograM SElECTIoN: Select the program (from 0 to 9) using the keys
3
SElECTINg THE vaC fuNCTIoN: Select the vaC function by means of key SEl
4 PrograMMINg THE vaC fuNCTIoN: Enter the program by pressing Prog
lthe digits on the display start flashing. Set the required value expressed in seconds or
percentage (in machines provided with vacuum sensor) using the keys
means of Prog or proceed with programming the successive functions by pressing
5
SEl 6 .
5
SElECTINg THE SEal fuNCTIoN: Select the SEAL function by means of SEl
6
PrograMMINg THE SEal fuNCTIoN: The digits on the display start flashing. Set the required value
using the keys . Confirm by means of Prog
4
by pressing SEl
6
7
CoNfIrMINg THE PrograMMINg: There are three ways to confirm the program set:
• press Prog ;
5
• press SEl until the program number reappears and the display stops flashing;
6
• wait for about seven seconds without pressing any key.
It is now possible to proceed with other program settings, or proceed with packaging.
8
STarTINg THE work CyClE: Lower the lid with both hands pressing slightly on the corners. The ap-
pliance will start the work cycle according to the programmed parameters.
Instruction manual for vacuum chamber packaging machines Mod. BV 400/25 – BV 400/25H – BV 600/60
Rev. 01 - 04/2019 - Cod. 1500656 - Instruction manual for vacuum chamber packaging machines Mod. C46-C46H-C62
5
5
PROG
4
4
: Turn On the main switch on the control panel
. For bags with basic weight 90/100, set the value as 2.2÷3 seconds.
Instruction manual for vacuum chamber packaging machines Mod. BV 400/25 - BV 600/60
6
6
PUMP
SEL STOP
or proceed with programming the successive functions
5
8
8
; the LED in the switch
2
4
.
6
.
:
5
. Confirm by
4
6
.
2
23