Peg-Perego Primo Viaggio Convertible Kinetic Mode D'emploi page 47

Installing your child restraint in the vehicle - Forward Facing mode
4. Buckle the vehicle belt and check that the
5 6
vehicle belt is free of any entanglement.
5. Push the child restraint firmly into the
A
vehicle seat (A) and pull the vehicle belt (B) in
order to tighten the seat, eliminating any slack.
6. Make sure that the belt passes through
the opened lockoff clips and then close
D
them on both sides following the procedure
B
C
shown in picture (C and D).
7. Picture shows the correct belt pattern
when the product is installed in the forward
facing mode using a lap belt.
7
Verify that the child restraint is secure. A
secure child restraint will not move more than
2.5 cm (1 inch) near the seat belt anchors.
Important Note: The lock off clips located on the
side of the Primo Viaggio Convertible Kinetic seat
are used to enhance the stability during normal
use. The lock offs are not designed to replace an
automatic locking retractor or a locking latch plate.
- 47 -