Peg-Perego Primo Viaggio Convertible Kinetic Mode D'emploi page 33

Installing your child restraint in the vehicle - Rear Facing mode
5. Attach the lower connectors to the lower
5
A
anchors of your vehicle located at the joint line
between seat and backrest. Check your vehicle
B
owner's manual to learn what is the best place
B
for your child restraint. When the UAS straps are
connected to the lower anchors, an audible click
will be heard. If this is not the case, repeat the
operation and double check that the latch is
attached and working by trying to pull the lower
connector away from the lower anchor.
6. Push down the child restraint (A) into the seat
with your own body weight and at the same
time pull the strap ends in order to tighten the
7
latch straps (B). Check that the connectors are
evenly tightened and that the seat is not leaning
sideways.
7. Picture shows the correct strap path when the
seat is attached using the UAS connectors. Make
sure the seat is properly leveled as explained on
page 29.
Verify that the child restraint is secure. A secure
child restraint will not move more than 2.5 cm
C
(1 inch) near the latch anchors.
- 33 -