Peg-Perego Primo Viaggio Convertible Kinetic Mode D'emploi page 42

Installing your child restraint in the vehicle - Forward Facing mode
5. Take each UAS strap from front to rear sliding the
5 6
straps along their tubing.
6. Attach the lower connectors to the lower anchors
of your vehicle located at the joint line between
seat and backrest. Check your vehicle owner's
manual to learn what is the best place for your car
. When the UAS straps are connected to the lower
anchors, an audible click will be heard. If this is not
the case, repeat the operation and double check
that the latch is attached and working by trying
to pull the lower connector away from the lower
anchor.
7. Push down the child restraint (A) into the seat
7 8
with your own body weight and at the same time
pull the strap ends (B) in order to tighten the
a
latch straps. Check that the connectors are evenly
tightened and that the seat is not leaning sideways.
b
8. Picture shows the correct strap path when the
child restraint is attached to the vehicle using the
UAS connectors.
Verify that the child restraint is secure. A secure
child restraint will not move more than 2.5 cm (1
inch) near the UAS anchors.
- 42 -