Peg-Perego Primo Viaggio Convertible Kinetic Mode D'emploi page 45

Installing your child restraint in the vehicle - Forward Facing mode
5. Push the child restraint firmly into the vehicle seat
5 6
and pull the vehicle belt eliminating any slack. While
pushing the seat down (A), pull the lap portion of the
A
C
belt from the fixed point toward the buckle (B). Then
pull the diagonal portion of the belt (C).
6. Close the lockoff clip following the procedure
shown in picture (D and E).
E
Make sure that only the lap portion of the belt passes
B
through the opened lockoff clip on the side where
D
the shoulder strap goes up to the retractor (picture 6).
7. Open the lockoff clip on the buckle side. Make sure
that both the lap and shoulder belts go through the
lockoff near the buckle. Close the lockoff clip following
7
the procedure shown in picture 6 (D and E).
Verify that the child restraint is secure. A secure child
restraint will not move more than 2.5 cm (1 inch)
near the seat belt anchor.
Important Note: The lock off clips located on the side
of the Primo Viaggio Convertible Kinetic seat are used
to enhance the stability during normal use. The lock
offs are not designed to replace an automatic locking
retractor or a locking latch plate.
- 45 -