Table des Matières
Publicité
Installing your child restraint in the vehicle - Rear Facing mode
4. Buckle the vehicle belt and check that it is
4
5
threaded below the adjuster strap and not
entangled with it.
A
5. Push the seat firmly into the vehicle seat
(A) and pull the vehicle belt (B) in order
to tighten the seat, eliminating any slack.
click
B
6. The picture shows the correct belt path
when the seat is attached to the vehicle using
6
a lap belt .
Once the installation is completed check that
the seat is properly levelled following the
section on page 29.
Verify that the child restraint is secure. A
secure child restraint will not move more than
2.5 cm (1 inch) near the seat belt anchors.
- 40 -
Publicité
Table des Matières
