Table des Matières
Publicité
Installing your child restraint in the vehicle - Forward Facing mode
Important! Remove newborn filler cushion in
forward facing mode (see page 54).
IMPORTANT: make sure that the Anti-Rebound Bar
is properly stowed when using the seat forward
facing as shown in page 31.
FORWARD FACING MODE USING LAP/
SHOULDER BELT (TYPE II)
1. Before installing the child restraint, make sure that
the backrest is in the upright position or adjust it
using the handle below the front edge of the shell
(A) as shown in detail.
2. Lean the upright child restraint, unoccupied, on the
selected vehicle seat. Make sure that the UAS straps
are stored in their proper location (page 41 - picture 1)
and that the rear openings in the structure are free and
ready for use. Open the lock off clips on both sides as
shown in the picture.
3. Pull the vehicle belt at full available length and
thread both the lap and shoulder portions of the belt
through the openings in the structure behind the
child restraint as shown in the picture.
4. Buckle the vehicle belt and check that the vehicle
belts are both threaded through the openings, free
of any entanglement.
A
A
- 44 -
2
1
B
3
4
Publicité
Table des Matières
