Table des Matières
Publicité
Installing your child restraint in the vehicle
Lap/shoulder belt (3-point) with Switchable
Locking Retractor (ELR —> ALR) and free
sliding latch plate. This type of seat belt has
a latch plate that moves freely along the belt.
To activate the ALR mode, pull the belt all the
way out. Some vehicles may require another
activation method (check vehicle owner's
manual for details). Once activated, the belt
will not extend unless allowed to retract all the
way.
Rear facing installation can be done using
the ALR or a locking clip. In some vehicles,
the shoulder strap can tend to tilt the seat
sideways when tightened.
locking clip may provide a better installation.
The use of a locking clip is explained on page 37.
Forward facing installation should be done
with the ALR and the lock off clips located on
the sides of the seat.
Mode detailed installation instructions begin
on page 29.
Important Note: The lock off clips located
on the side of the Convertible seat are used to
enhance the stability during normal use. The lock
offs are not designed to replace an automatic
locking retractor or a locking latch plate. The
vehicle belt must be properly tightened to secure
the Convertible seat to the vehicle.
In this case, a
- 18 -
ELR
ALR
1
FF
RF
Publicité
Table des Matières
