Forward Facing Mode Using Lap Belt (Type I) - Peg-Perego Primo Viaggio Convertible Kinetic Mode D'emploi

Installing your child restraint in the vehicle - Forward Facing mode
Important! Remove newborn filler cushion in
1 2
forward facing mode (see page 54).
A
IMPORTANT: make sure that the Anti-Rebound
Bar is properly stowed when using the seat
forward facing as shown in page 31.
B
FORWARD FACING MODE USING
LAP BELT (TYPE I)
1. Before installing the child restraint in the
vehicle, make sure that the backrest is in the
A
upright position or adjust it using the handle
located below the front edge of the shell (A) as
3
4
shown in detail.
2. Lean the upright child restraint, unoccupied, on
the selected vehicle seat. Make sure that the UAS
straps are stored in their proper location (page
41 - picture 1) and that the rear openings in the
structure are free and ready for use. Open the
lock-off clips, as shown in the picture .
3. Pull the vehicle belt at full available length
and thread the belt through the openings in the
structure behind the child restraint as shown in
the picture.
- 46 -