Table des Matières
Publicité
Installing your child restraint in the vehicle - Rear Facing mode
REAR FACING MODE USING
UAS SYSTEM
1. Recline the child restraint to the rearfacing
position as shown in the picture. To recline the
child restraint, pull the handle located below
the front edge of the shell (A) as shown in de-
tail. An audible "click" is heard when the seat is
properly locked into position.
as shown in the previous section.
Note: for easier adjustment, lift the back of the
seat slightly with your free hand to remove
some weight from the mechanism.
2. Disconnect the latch
bar by pushing on the red button
the straps at the same time.
3. Slide the straps toward the front of the child
restraint. Check that the straps are not reversed.
4. Lean the reclined seat, unoccupied, on the
selected vehicle seat in the rearfacing mode
making sure that the front part of the seat
touches the vehicle seat backrest.
Deploy the ARB
straps from the storage
and pulling
- 32 -
1
A
B
A
3
2
4
Publicité
Table des Matières
