Peg-Perego Primo Viaggio Convertible Kinetic Mode D'emploi page 15

Installing your child restraint in the vehicle
UAS SYSTEM: Primo Viaggio Convertible Kinetic is equipped with latch connectors. They are
located at each side of the child seat that attach to anchors located at the junction of the seat
and backrest in your vehicle. There are two anchors for each seating position and they are
spaced by about 28 cm (11").
They may be visible or slightly recessed into the vehicle uphostery and can be protected by
plastic or fabric shields. The UAS anchor can be located by this symbol:
Check your Vehicle Owner's Manual to find the
UAS anchor locations in your vehicle.
IMPORTANT NOTE: Unless where specified
differently, lower anchors (UAS) may be used
for a child whose weight is less than 18 kg (40
lbs). However most lower anchors can withstand
much greater forces. Please, check your
vehicle owner's manual or contact the vehicle
manufacturer in order to determine what the
weight limit is for the use of lower anchors.
When the weight of occupant is beyond these
limits, vehicle seatbelt must be used to install
the child restraint properly and securely.
- 15 -
11"