Publicité
Les langues disponibles
Les langues disponibles
4) If installing the sprockets without the plastic
support, install the individual or preassembled
sprockets and the spacers on the sprocket body
of the hub aligning the spline patterns (Fig.
3). The profile of the freewheel body with two
asymmetrical grooves (Fig. 3) ensures automatic
sprocket timing since there is only one assembly
option.
5) Using a torque wrench (D - Fig. 4) together
with the Campagnolo
tool UT-BB080 (B - Fig. 4),
®
tighten the ring nut (G - Fig. 4) that came with the
Campagnolo
sprocket pack onto the freewheel
®
body, observing the tightening torque indicated
on the instruction sheet of the sprocket pack.
1) Remove the lockring (G - Fig. 5) using the
Campagnolo
tool UT-BB080 (B - Fig. 5) with
®
a 24 mm hexagonal wrench (E - Fig. 5) and the
chain whip Campagnolo
UT-CS060 (F - Fig. 5).
®
2) Insert the plastic sprocket carrier on the side
of the freewheel body and align the spline pat-
terns on the body with those on the carrier. Slide
the sprockets onto the carrier.
3) Slide the sprockets, off the freewheel body
(Fig. 6).
3
4.2.2 - DISASSEMBLY
G
C
B
E
E
UT- BB080
UT-BB080
F
F
UT-CS060
UT-CS060
APRIRE
OPEN
OPEN
ÖFFNEN
5
C
G
UT -BB080
UT-BB080
B
B
4
B
6
D
D
40 N.m - 29.5 lb.ft
CLOSE
7
Publicité
