Hot Surfaces; Hazardous Materials; Suction Danger; Defects - BADU Block Multi 100 Traduction Du Instruction D'utilisation Originale

Safety
– Attach a warning sign: "Do not switch on! The system is
being worked on."
– Ensure that the system is free of voltage.
Check the electrical system regularly to ensure it is in proper

working condition.
Pos: 56 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Restrisiken/Heiße Oberfläche Motor @ 0\mod_1427781274683_370.docx @ 26707 @ 3 @ 1
2.7.5

Hot surfaces

The electric motor can reach temperatures of up to 70 °C. There
is a risk of being burned.
 Do not touch the motor during operation.
 Allow the pump/unit to cool down before servicing it.
Pos: 57 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Restrisiken/Gefahrstoffe @ 0\mod_1427782200424_370.docx @ 26722 @ 3 @ 1
2.7.6

Hazardous materials

 Ensure that leaks of dangerous pumped fluids/gases are led
away without endangering people or the environment.
 Decontaminate the pump completely during disassembly.
Pos: 58 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Restrisiken/Ansauggefahr @ 0\mod_1427783303305_370.docx @ 26737 @ 3 @ 1
2.7.7

Suction danger

Ensure that the suction openings conform to current guidelines,
standards and instructions.
Pos: 60 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Störungen/Störungen @ 0\mod_1427783778053_370.docx @ 26752 @ 2 @ 1
2.8

Defects

In case of a defect, immediately switch the pump off and

remove it from operation.
 Have all defects repaired immediately.
Pos: 61 /Technische Dokumentation/Betriebsanleitung/Sicherheit/Störungen/Festsitzende Pumpe @ 0\mod_1427784418208_370.docx @ 26767 @ @ 1
Seized pump
If a pump seizes, and is switched on several times repeatedly, the
motor can be damaged. Observe the following points:
Do not switch the pump/unit on repeatedly.

 Turn motor shaft. See chapter 6.1.3 on page 30.
 Clean pump.
Pos: 62 /Technische Dokumentation/Allgemeine Module/#### Seitenumbruch #### @ 0\mod_1426069111812_0.docx @ 891 @ @ 1
12 EN 04/2016