Manitowoc UnderCounter Q130 Serie Mode D'emploi page 19

Section 4
H. Remove the ice damper.
Q130
• Grasp left side of ice damper and apply pressure
against the right-hand ice damper mounting bracket.
• Pull forward on the ice damper until the left-hand
mounting pin disengages.
Installation
• Grasp the right side of ice damper and place left
hand pin in the mounting bracket.
• While applying pressure against the left-hand
mounting bracket push the damper until the right-
hand mounting pin engages.
Q170/Q210/Q270
• Grasp ice damper and apply pressure toward the left
hand mounting bracket.
• Apply pressure to the right hand mounting bracket
with thumb.
• Pull ice damper forward when the right hand ice
damper pin disengages.
Installation
• Place ice damper pin in left hand mounting bracket
and apply pressure toward the left hand mounting
bracket.
• Apply pressure to the right hand mounting bracket
with thumb.
• Push ice damper toward evaporator until right hand
damper pin engages.
Part Number 040002380 9/12
I. Remove the Bin Door
• Grasp the rear of the bin door and pull bin door
forward approximately 5".
• Slide bin door to the rear while applying upward
pressure (The rear door pins will ride up into the track
slot and slide backward to the stop tab).
• While applying pressure against the bin door pull
down on the rear of each bin door track until the door
pins clear the stop tabs.
• Slide the rear door pins off the end and then below
the door track. Slide bin door forward allowing the
back of the door to lower into the bin. Continue
forward with the bin door until the front pins bottom
out in the track.
• Lift right side of door until the front pins clear the
track, then remove door from bin.
• Remove rollers (4) from all door pins.
STOP TAB
TRACK SLOT
Maintenance
PRESS DOWN TO
RELEASE DOOR
SLIDE DOOR
FORWARD
ROLLER
19