Squeegee Maintenance; Squeegee Adjustment - Advance HydroCat 5015G Mode D'emploi

SQUEEGEE MAINTENANCE

After each use, clean the squeegee tool and check the blades for damage. Reverse or replace the blades if they are nicked, torn or worn to a radius.
To Reverse or Replace the Rear Squeegee Wiping Blade...
1 Unsnap the center Latch on the squeegee tool.
2 Remove the Wing Nut from each end of the squeegee, then remove the Tension Straps.
3 Slip the rear blade off the Alignments Pins.
4 The rear squeegee blade has 2 working edges. Turn the blade so a sharp 90° edge points toward the front of the machine and against the fl oor. Replace
the blade if both edges are nicked, torn or worn to a radius.
5 Install the blade, following steps 1-3 in reverse order.
To Reverse or Replace the Front Squeegee Blade...
1 Remove the two nuts from the Squeegee Adaptor and remove the adapter from the squeegee.
2 Loosen the four "T" Bolts and slide the squeegee tool off the mounts.
3 Remove the hex nuts that hold the front blade in place and remove the blade.
4 The front squeegee blade has 2 working edges. Turn the blade so a sharp 90° edge points toward the front of the machine and against the fl oor.
Replace the blade if both edges are nicked, torn or worn to a radius.
5 Install the blade, following steps 1-3 in reverse order.

SQUEEGEE ADJUSTMENT

Adjust the squeegee if it leaves water in the middle or at both sides of its path.
To Adjust the Squeegee...
1 Park the machine on a level fl oor and lower the squeegee.
2 Turn the Squeegee Adjustment Bolts equally to tilt the squeegee tool until the squeegee blades touch the fl oor evenly across the entire width of the
squeegee tool.
Squeegee Adjustment Bolt
Wing Nut
43 - FORM NO. 041357 / HYDRO-RETRIEVER 5015G/P
The 2 wiping edges of the rear blade.
Squeegee Adapter
T-Bolt
Latch
A
B
Squeegee Adjustment Bolt
Alignment Pin
Tension Strap