Filling The Solution Tank; Squeegee Installation - Advance SC900 ST Série Mode D'emploi

FILLING THE SOLUTION TANK

Fill the solution tank with a maximum of 30 gallons (113.5 Liters) of cleaning solution. Do not ll the solution tank above 7.5 cm (3 inches) from the
bottom of the Solution Fill (1). The solution should be a mixture of water and the proper cleaning chemical for the job. Always follow the dilution
instructions on the chemical container label. NOTE: EcoFlex machines can either be used conventionally with detergent mixed in the tank or the
detergent dispensing system can be used.
CAUTION!
Use only low-foaming, non- ammable liquid detergents intended for machine application. Water temperature should not exceed 130
degrees Fahrenheit (54.4 degrees Celsius)

SQUEEGEE INSTALLATION

1 See Figure 4. Slide the Squeegee Assembly (12) onto the Squeegee Mount Bracket (M) and tighten the Squeegee Mount Thumb Nuts (33).
IMPORTANT!: HAND TIGHTEN THE SQUEEGEE THUMB NUTS ONLY, DO NOT USE TOOLS.
2 Connect the Recovery Hose (34) to the squeegee inlet.
3 The Squeegee Mount Bracket (M) has a factory set position so that the rear squeegee blade touches the oor evenly across its entire width
and is bent over slightly as shown.
NOTE: A service technician can adjust the Turnbuckle Assembly (N) to change the squeegee angle if needed.
FIGURE 4
N
11/2015
34
33
M
INSTRUCTIONS FOR USE
12
33
1
56091183 - SC900 ST
ENGLISH - A
A - 13