Brush or pad-holder removal/installation (REV™
system)
1.
Make sure that the REV™ deck (37) is lifted.
2.
Turn off the machine and remove the operator key (41).
3.
According to the kind of cleaning to be performed, install
the pad (A, Fig. 3) or the brush (C, optional) and note the
following:
•
Place the pad (A) under the deck and press it until it is
fastened with the Velcro of the drive disc (B).
•
Place the brush (C, optional) under the deck, and then
match the centering pins (D) to the respective holes of
the drive disc (B), and then engage the brush with the
three mounting screws (E).
4.
To remove the pad or brush, proceed in the reverse order.
Squeegee installation
1.
Install the squeegee (A, Fig. 4) and fasten it to the bracket
(C) with the handwheels (B).
2.
If necessary, adjust the squeegee with the knob (D) so that
the rear blade (E) and front blade (F) touch the floor as
shown in the figure.
Solution tank filling
CAUTION!
Use only low-foam and non-flammable
detergents, intended for automatic scrubber
applications.
WARNING!
When using floor cleaning detergents, follow
the instructions on the labels of the detergent
bottles.
To handle floor cleaning detergents, wear
suitable gloves and protections.
NOTE
If the machine is equipped with EcoFlex™ system
pour clean water in the tank, otherwise pour solution.
1.
Ensure that the solution valve (18) is open (18-A).
2.
To fill the solution tank (21) use the front filler (22), or open
the cap (24) to access the side filler.
(For machines without EcoFlex™ system)
3.
Fill the tank (21) with a solution suitable for the work to be
performed.
Do not fill the tank completely, leave a few inches from the
edge. Use the level hose (13) as reference.
Always follow the dilution instructions on the label of the
chemical product used to prepare the solution.
The solution temperature must not exceed 40 °C.
11/2014
INSTRUCTIONS FOR USE
C
D
Figure 3
F
Figure 4
9099980000 - SC500
ENGLISH
B
A
E
P100857
C
A
B
D
B
E
P100843
13