Binding; Assembly - Horizon Hobby Apprentice S 2 1.2m Manuel D'utilisation

Binding

The receiver must be bound to your transmitter before it will operate. Binding
is the process of teaching the receiver the specific code of the transmitter so it
will only connect to that specific transmitter.
The included RTF transmitter is bound to the aircraft at the factory. If you need
to re-bind for any reason, follow the binding procedure as shown.
An extension is installed in the flight controller bind port so binding may be
done through the battery door in the bottom of the aircraft without having to
remove the wing assembly. Simply insert the bind plug in the open end of the
extension marked "BIND" to enter bind mode.
1. Install a bind plug in the bind port extension.
2. Connect the flight battery to the ESC. The orange receiver LED starts to
flash continuously, indicating the receiver is in bind mode.
3. Power on the transmitter while holding the transmitter bind button or
switch. Refer to your transmitter's manual for specific binding instructions.
4. The bind process is complete when the orange LED on the receiver is solid.
5. Remove the bind plug from the bind port extension.

Assembly

For video assistance regarding assembly, visit the
Apprentice product page at www.horizonhobby.com
Landing Gear Installation
1. Install the main landing gear assembly (A) into the slot on the bottom of the
fuselage.
2. Place the 2 landing gear brackets (B) into location as shown, noting the
Right and Left indicators.
3. Secure the landing gear assembly into place using 4 screws (C).
4. Install the front straps (D) using the 4 screws (E) to ensure that they do not
become lost. The front straps are required to install the optional Float Set
and Mounting Wires (HBZ7390).
IMPORTANT: Do Not use the propeller that is included with the float set.
Tail Installation
1. Install the horizontal tail (A) on the fuselage under the linkages as shown.
2. Carefully insert the 2 pins (B) of the vertical fin (C) through the horizontal
tail holes into the fuselage holes.
3. Under the fuselage, install the 2 screws (D) into the fuselage and the
vertical fin pins. Tighten the screws, but do not break the plastic.
4. Connect the respective clevises in the outermost holes in the rudder and
elevator control horns. Refer to the clevis adjustment instructions to center
the rudder and elevators.
Disassemble in reverse order.
1
®
C
B
A
1
A
E
D
2
2
3
8
C
B
D