Control Direction Test - Horizon Hobby Apprentice S 2 1.2m Manuel D'utilisation

Control Direction Test

IMPORTANT: All trimming and control test should be done before throttle is
advanced and in Experienced Mode.
Power on the transmitter. Make sure the throttle is at 0% and that throttle trim
is fully lowered on the transmitter. Power on the model. Make sure the control
surfaces (rudder, elevator and ailerons) are at neutral or 0 degrees. Ideally,
centering trim will center the surfaces. Refer to Control Centering instructions
Transmitter Command
®
to adjust control surfaces. Move the transmitter control sticks so the model's
rudder, elevator and ailerons move as shown (illustrations show a view from
the rear of the aircraft). If your model does not respond correctly, DO NOT FLY!
See the Troubleshooting Guide in this manual for more information. If you need
more assistance, contact the appropriate Horizon product support department.
Control Surface Response
12